Coloronix 6″ Recessed RGBW Downlight User Manual

RGBW RECESSED LIGHTING MANUAL Coloronix, Inc. 5461 West Jefferson Boulevard Los Angeles, California 90016 (323) 677-4242

Installing Fixture Installing Housing Rough-In Area Using a ½” electrical conduit, install the fixture into the ceiling cavity. You may use the fol

Installing Trim Installing assembly: insert torsion springs into spring receivers (found in housing). For 3” round, insert trim held in place by sp

Data Connection Note: Fixtures on a serial data link must be daisy chained in one single line. To comply with the EIA-485 standard, no more than 32

Troubleshooting Guide If does not light, check if: Electrical power is not connected. Electrical power is less than specific voltage. Electric

Further Troubleshooting Should problems occur while using the product, unplug it at once and contact: Coloronix, Inc. Tech Support: (909) RGBW-555 s

Warranty Information 3 YEAR PRODUCT LIMITED WARRANTY Coloronix, Inc. provides a warranty to LED housings and LED trims in case of physical or assem

Coloronix, Inc. © 2011 Coloronix, Inc. All rights reserved. According to copyright laws, this manual may not be copied—partially, or wh

Contents Summary 4 Introduction 4 Scope 4 Who is this manual intended for? 4 Additional Supplies 4 Safety 5 Hazard Icon Key 5 Specifications

Summary Introduction RGBW Color Changing Downlights are active, top-of-the-line color changing fixtures. They draw on solid-state elements in orde

Safety Hazard Icon Key: The “ DANGER” icon means avoiding pending danger will result in serious injury, or death. The “ WARNING” icon means avo

Planning for Installation Unpacking The data enabler and trim are shipped assembled with no additional assembly needed. Housing and trim are shi

Setting Color Mode (Optional) Dip Switch Inside Housing For installations requiring DMX control, set the personalized

Dip Switch Setting DMX Channels 1,5,9 273-276 1,3,5,9 277-280 1,4,5,9 281-284 1,3,4,5,9 285-288 1,6,9 289-292 1,3,6,9 293-296 1,4,6,9 297-300 1,3,4,

ColorRay Stand Alone Mode For application not using DMX control, user can preprogram shows. The fixture’s on board computer have been pre-configure